CD4066B CD4066BE CD4066 CMOS Quad Bilateral Switch DIP14 US Seller

Description

CD4066B CD4066BE CD4066 CMOS Quad Bilateral Switch DIP14
Description
CD4066B is a quad bilateral switch intended for the transmission or multiplexing of analog or digital signals. It is pin-for-pin compatible with the CD4016B, but exhibits a much lower on-state resistance. In addition, the on-state resistance is relatively constant over the full input-signal range.
The CD4066B consists of four bilateral switches, each with independent controls. Both the p and the n device in a given switch are biased on or off simultaneously by the control signal. As shown in Figure 1, the well of the n-channel device on each switch is tied to either the input when the switch is on or to VSS when the switch is off. This configuration eliminates the variation of the switch-transistor threshold voltage with input signal and, thus, keeps the on-state resistance low over the full operating-signal range.
The advantages over single-channel switches include peak input-signal voltage swings equal to the full supply voltage and more constant on-state impedance over the input-signal range. However, for sample-and-hold applications, the CD4016B is recommended.
Features
15-V Digital or ±7.5-V Peak-to-Peak Switching
125 Ohm Typical On-State Resistance for 15-V Operation
Switch On-State Resistance Matched to Within 5 Ohm Over 15-V Signal-Input Range
On-State Resistance Flat Over Full Peak-to-Peak Signal Range
High On/Off Output-Voltage Ratio: 80 dB Typical at f
is
= 10 kHz, R
L
= 1 kΩ
High Degree of Linearity: <0.5% Distortion Typical at f
is
= 1 kHz, V
is
= 5 V p-p, V
DD
–V
SS
Extremely Low Off-State Switch Leakage, Resulting in Very Low Offset Current and High Effective Off-State Resistance: 10 pA Typical at V
DD
–V
SS
= 10 V, T
A
= 25°C
Extremely High Control Input Impedance (Control Circuit Isolated From Signal Circuit): 10
12
Ohm Typical
Low Crosstalk Between Switches: –50 dB Typical at f
is
= 8 MHz, R
L
= 1 kOhm
Matched Control-Input to Signal-Output Capacitance: Reduces Output Signal Transients
Frequency Response, Switch on = 40 MHz (Typical)
100% Tested for Quiescent Current at 20 V
5-V, 10-V, and 15-V Parametric Ratings
Meets All Requirements of JEDEC Tentative Standard No. 13B,
Standard Specifications for Description of B-Series CMOS Devices
Applications:
Analog Signal Switching/Multiplexing:
Signal Gating, Modulator, Squelch Control, Demodulator, Chopper, Commutating Switch
Digital Signal Switching/Multiplexing
Transmission-Gate Logic Implementation
Analog-to-Digital and Digital-to-Analog Conversion
Digital Control of Frequency, Impedance, Phase, and Analog-Signal Gain
TERMS OF SALE
We welcome FPO/APO/Military Orders.
APO/FPO ships at domestic rates.
New Bidders, International bidders welcome - we are flexible on customs declarations.
Any questions eoi at lunaticlabs.biz
WINDHAGBATS